Tie-down Vector Dynamics Foundation System for Wind Zones l Instrukcja Użytkownika Pobierz pdf (Strona 9)

For metal piers, place the piers in the center of the Vector pads.

Setthesingle4x4ortwo2x4’sthroughthepiers,centeredinthe

U-bolts,sothattheboard(s)overhangsthepierbaseoneachside

byabout2”.OutsideTensionbracketsattachthesame,Insidetie

bracketsmount“upsidedown”asshownindrawing.Metalpiers

using the Vector Ground System can only be used on level ground

sets. Concrete pad sets would be set normal.

Conventional pier adjusters must be placed under beam with

upturned edge directed towards the outside of the home.

Pier spacing must be consistent with home manufacturers’ installation instructions and/or state requirements.

Tocutlumber(2-2x4’sor1-4x4per,or1adjustablesteelcompressionmember)forthecentercompression

section,whenusingMETALPIERSTANDS,measurecentertocenterframedistanceandadd16”.OptionalMoisture

TermiteShieldmayberequiredincertainregions.ALLWOODMUSTBEPRESSURETREATED,GROUNDCONTACTRATED.

Tip: Pre-cut your lumber and mark as to brand or model of homes you will be installing. If frame widths are

the same, the pre-cut boards will also be the same length in each Vector set-up.

Metal Pier Ground Set Foundations

V-Drive System

for Rocky Soil Conditions

V-Drive anchors are used only in Zone I,

single section homes in areas where rocky

soilconditionsdonotallowhelixstyle

anchors to be installed.

Vector Systems are set following the

general set up instructions provided. With

theV-Driveanchor,theshort2x4boards

usedwiththeoutsidetensionbracketsarediscarded.Inplaceoftheshort2x4’s,alonger2x4isusedasperthe

diagramabove.This2x4boardshouldextendfromthebaseoftheVectorpiersetto5inchesfromthesidewall

of the home.

Place the V-Drive head over the end of the longer board. Using a heavy hammer or electric hammer gun, drive

thethreeV-DriveanchorrodsthroughtheV-Driveheadsatanangleofapproximately45degreesunderthehome.

The rods must come to a complete stop on the V-Drive head. Attach a strap with hook, buckle or swivel to the

frame and attach to the V-Drive head with a slotted bolt. Cut the strap end about 12 to 15 inches past the anchor

head to allow at least four or five wraps around the slotted bolt. Continue tightening strap until all slack is out and

strap is tight.

V-Drive Anchors are used only in

Zone I, for Single Section Homes

9 Revised: 8/19/08

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Brak uwag

Tie-down Vector Dynamics Foundation System for Wind Zones l Instrukcja Użytkownika Strona 9